Since i am not going to be running the stock fender liner, i felt it was best to tuck my chassis harness a bit better then it is stock..

1 reason, i dnt want to run the risk of my wheels  rubbing agains the harness and causing a short or tear at  the harnes..

2nd i wanted to clean the the chassis and under the fenders( didnt want any spiders and dirt under there lol)

so what i basically did was first removed the bumper.

then i removed the fenders from the Chassis.

upon removing the fenders the first time. i found cobwebs, spiders, and lots of dirt..

basically i cleaned up it up, wiped it down. then i began looking to see where was a good spot to zip tie the harness, and also routed the harness a bit higher(so it sits directly under the top of the frame(right under the fenders).

thats basically what it looks like from the wheel well on the inside.. the wires are sitting on the frame away from the wheels…

here an ass shot of my fd lol

-zero